Euro Machinist Square 75mm X 50mm (1-5/8 Inch) Meco Midget Torch 430 must be purchased separately

430 must be purchased separately if not using a complete Profiform system

Acid testing with test needles is an entirely subjective method and requires careful observation and practice to master

2-speed operation: 1800 RPM (low) and 3600 RPM (high)

GRS Standard Engraving Blocks

and fitting of jewelry components

Euro Machinist Square 75mm X 50mm (1-5/8 Inch) Meco Midget Torch 430 must be purchased separatelyMachined from bar stock (billet) one piece stainless steel construction to DIN 875 II standards. A machinist square is the metalworker's equivalent of a woodworker's try square. Its primary purpose is measuring the accuracy of a right angle (90 degrees). To "try" a surface is to check its straightness or correspondence to an adjoining surface. A small notch has been added to the inside corner of the square to prevent small particles from accumulating