Inline Fabrication - Spacer for Flush Mount Base Stabilizer 4 PL/HL 6019

4 PL/HL 6019

This gage is intended to be used with fired cases to determine a basis for full length sizing and case trimming

they disturb the powder kernels from trying to jam up at the neck

Comes with:

1mm rubber base

Inline Fabrication - Spacer for Flush Mount Base Stabilizer 4 PL/HL 6019Requiered if you are not routing the flush mount base into your bench. The flush mount baseplate was designed to be routered into your bench to provide a nice flat benchtop. However, If you don't want to route your bench top (i. e, mount it directly to the surface ) you must install this shim plate to raise it up a touch to allow the quick change top plate tongues to drop in and out. Note: You still need the flush mount quick change baseplate